IATF 16949: 2016 — 21 Mandatory Procedure
SOME FACTS ABOUT IATF16949: 2016 IATF 16949:2016 was published by the “International Automotive Task Force ” (IATF) On October 3rd, 2016, supersedes and replaces the current ISO/TS 16949, defining the requirements of a quality management system for organizations in the automotive industry.
- IATF 16949:2016 is aligned with ISO9001:2015 and so cannot be implemented alone as a stand-alone document, but with ISO 9001:2015.
- 14th September 2018 is the last date when the validity of ISO/TS 16949:2009 certificate ends.
- No audits of ISO/TS 16949:2009 (initial, surveillance, recertification or transfer) will be possible and accepted from 1st October 2017.
- Product Safety — 4.4.1.2
- Calibration—7.1.5.2.1
- Training – 7.2.1
- Internal Auditor competency – 7.2.3
- Employee Motivation—7.3.2
- Engineering Specification 7.5.3.2
- Design and Development – 8.3.1.1
- Special Characteristic Defining –8.3.3.3.
- Supplier Selection—8.4.1.2.
- Out sources Process –8.4.2.1
- Statutory and regulatory requirement — 8.4.2.2
- Supplier Monitoring — 8.4.2.4
- Control of changes—8.5.6.1.
- Temporary Change – 8.5.6.1.1
- Rework Procedure — 8.7.1.4
- Repaired Procedure – 8.7.1.5
- Disposition of non-conforming products –8.7.1.7
- Internal Audit Process —9.2.2.1
- Problem Solving — 10.2.3
- Error proofing – 10.2.4
- Continual Improvement — 10.3.1
PS: Please also read my article with this
2 Comments
Other Links to this Post
Diagnosis of IATF 16949:2016 clause – 8.7.1.4 Control of reworked products – QUALiTY ViVA — November 3, 2017 @ 8:36 pm
Diagnosis of IATF 16949:2016 clause – 8.7.1.5 Control of repaired products – QUALiTY ViVA — November 4, 2017 @ 9:21 pm
RSS feed for comments on this post. TrackBack URI
Leave a comment